Description
The Zev Technologies Generation 4 and 5 Magazine release for the GLOCK® is constructed from Billet 6061 Aluminum and Mil Spec hard anodized Black.
It has a Honeycomb non-slip face for a more tactile engagement surface.
The contact point on the mag release face is ergonomically angled to the rear to allow ease of manipulation in performing magazine changes
The Mag Release takes minutes to install with the use of needle nose pliers and a long shaft, slim, flat head screwdriver.
NOTE: It is easiest to remove and replace the factory GLOCK® Mag-release Catch Spring for the magazine release installation. Then installing it back in its pin position after you remove the factory unit and replace it with the ZEV component.
ZEV Parts always incorporate design, feel and performance.
- Honeycomb non-slip facefor a more tactile engagement surface
- The contact point on the mag release face is ergonomically angled to the rear to allow ease of manipulation in performing magazine changes
- Note: it is easiest to remove and replace theGLOCK Mag Catch Spring for the magazine release installation
Small Frame Compatibility:
GLOCK 17 Gen 4/5, GLOCK 19 Gen 4/5, GLOCK 19X, GLOCK 22 Gen 4/5, GLOCK 23 Gen 4/5, GLOCK 26 Gen 4/5, GLOCK 27 Gen 4/5, GLOCK 31 Gen 4, GLOCK 32 Gen 4, GLOCK 33 Gen 4, GLOCK 34 Gen 4/5, GLOCK 35 Gen 4, GLOCK 37 Gen 4, GLOCK 45
Large Frame Compatibility:
G20 Gen 4, G21 Gen 4, G29 Gen 4, G30 Gen 4, G40 Gen 4, G41 Gen 4
DISCLAIMER: This product is not manufactured, authorized, endorsed, or warranted by GLOCK. GLOCK does not warrant or represent that this product is compatible with GLOCK pistols.
